Peugeot 308 Key Fob: The Good, The Bad, And The Ugly

Peugeot 308 Key Fob Replacement

Peugeot’s 308 might seem a bit old, but it is still striking. It’s not the most luxurious car in its class, but it is an enjoyable and comfortable driving experience.

We are often asked at Coded Car Keys to replace peugeot 208 spare key key fobs. If the issue is intermittent or constant, the following tips should aid.

Water Damage

When you accidentally leave your key fob in a pool or get it wet during kayaking, swimming, canoeing, rafting, or canyoning, it’s most likely to suffer water damage. Keep your key fob in a dry container whenever you go outside or engage in things that expose it to excessive water.

It’s also crucial to make sure that the fob has dried out before you open it and use it again. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid), this is another indication that it’s been submerged.

A wet circuit can cause the battery’s charge to be drained or even explode. If you are able to get the 308 keyfob from the water you need to turn the button side up and shake as much water as you can prior to opening the casing. After opening it, take out the battery, and then clean the circuit board using an abrasive soaked in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not work include a dead battery in the coin-cell or receiver module issues signal interference or a malfunctioning chip. If none of the above are the issue, try resetting the system by disconnection of the battery at 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start that allows drivers to start their car from the distance, allowing them to warm up or cool down the vehicle prior to entering. This feature is extremely beneficial particularly in cold winter months. The remote start system may cease to function for a variety reasons, including a dead coin-battery.

A coin-shaped battery that is in the key fob has a life span of between two and four years, based on how much is a new peugeot key often it’s utilized and where it was purchased. The use-by date will be printed on the packaging or in the user manual.

If the key fob stops working after being exposed to clean tapwater, remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. In the event of exposure to soapy or salty water, the chip may be damaged and you’ll have to replace the key fob altogether.

If you are not sure the battery is defective you can check the voltage with an instrument set to the car’s voltage range and connected to the terminals for minus and plus. The voltage should range from 12-13 volts however, if it reads lower, then the battery needs to be replaced. If you want to, you can try to reset your on-board computer by disconnecting the battery with 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should now begin.

Faulty Receiver Module

If you’re unable to see the «Key Detected» message on your dashboard, then it’s possible that your receiver module has developed a fault. It’s the part that transmits the signal when your key fob goes off. It also functions as an alarm and prevents the vehicle from starting without the correct key.

This could be caused by several causes, such as water damage or just ageing. If your peugeot expert key; https://samuelsen-greenwood-5.blogbright.net, 308 key fob was exposed to dirty tap water, like, the electronic chip inside may be damaged. In this case it is necessary to take it apart and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once it’s dry, you can put the battery back into the battery and try again.

If the issue continues to persist the issue persists, it’s a good idea to seek out a local Peugeot specialist or locksmith. They will be able to use a diagnostic tool to identify the issue and repair it for you.

The loss of your Peugeot keys to your car is an incredibly stressful experience. A certified auto locksmith will be able to resolve the issue within minutes. They can program your vehicle and cut a new, working key for you. Click here to locate a locksmith near you.

Electronic chip malfunctions

The electronic chip that is in the Peugeot 308 key fob plays an essential role in the remote control system. If it becomes damaged, your car may not start, or you could receive a message saying «anti-theft active». If this occurs, the only solution to fix the issue is to purchase a new key. Luckily, auto locksmiths who are professionals are able to provide this service in the shortest time.

The chip in the chip of your Peugeot 308 key fob can fail due to water damage, sweat dirt, or other reasons. If your peugeot 307 replacement key cost key fob has been exposed soapy or dirty water, it should be cleaned right away. You can make use of a towel and isopropyl ethanol to clean the electronic component. After that, allow the battery to dry completely.

Radio interference can cause a key fob’s functionality to cease. This can happen when other devices use the same frequency as your peugeot 307 key programming keyfob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. If you experience this problem, it is best to visit an Peugeot dealership.

The Peugeot 207/308 Key Fob is fragile and requires particular care. It should not be dropped or throw it around. If you lose something, try to locate it as soon as you can. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first before connecting the positive.